Gallery - CNC Milling:

Part: Bellcrank - Motor sport

Material: 6082-t6

Operation:

Finish: Bead blast medium grade

Part: Rear upright - Motor sport

Material: 6082-t6

Operation:

Finish: bead blast medium grade

Part: Front uprights l/r - Motor sport

Material: 6082-t6

Operation:

Finish: Bead blast medium grade

Part: Vibration blocks - Aerospace

Material: stainless steel 316

Operation:

Finish: natural

Part: Location pot

Material: Graphite

Operation:

Finish: Natural

Part: Drive plate for special purpose assembly machine, 2.5" OD

Material: Black acetal

Operation: Machine central bore, machine 2.8mm drive slots, drill & ream studs in flange

Finish: Natural

Part: Locating body plate for aerospace application

Material: Stainless steel 304 S15, 3.15mm thick

Operation: Pressed fold, wirecut outside profile, CNC machined all holes, center holes bored with ±0.01mm tolerance, machined counter sinks

Finish: Bead blasted, full debur, packaged in sealed plastic envelope

Part: Centalising plate for atmospheric probe, aerospace

Material: Stainless steel 316, 3.15mm thick

Operation: Pressed profile, holes wire eroded with machined counter sink to ±0.05mm tolerance

Finish: Bead blasted and packaged in sealed plastic envelope

Part: Preparation plate for wire erosion of pendent jewellery for film prop, one off

Material: Stainless steel 304, 5mm

Operation: Bottom spot & drill start holes, mill pendent rebate to DXF provided by customer

Finish: Polished

Part: Isolator shaft adaptor

Material: Stainless steel 321 10mm²

Operation: Drill & ream securing pin hole, drill & ream spring hole, CNC machine down to 8mm² from 10mm² stock material

Finish: Polished ends, colour natural

Part: Inspection gauge

Material: Free issue aluminium casting 70mm²

Operation: Fully machined all faces, drill & tap securing thread M8, drill & bore central holes with inline concentricity ±0.02mm tolerance, securing screw & swivel pad bought out items

Finish: Hard anodised

Part: Interlock switch body for electrical switch gear application

Material: Aluminium HE30, 19mm x 25mm

Operation: CNC machined holes, counter bores & slots on 3 sides

Finish: Anodised natural/silver (chromic acid)

Part: Probe fixing plate for aerospace application

Material: Stainless steel 316, 3.15mm thick

Operation: Pressed profile, machine holes, counter bore with ±0.01mm tolerance on center hole

Finish: Bore masked & bead blasted, packaged in sealed plastic envelope

Part: Lateral location plate for aerospace sensor probe application

Material: Stainless steel 304, 3.15mm thick

Operation: Wire cut outside profile, ends formed on press tool, center hole machined to ±0.01mm tolerance, machined counter sink

Finish: Hole masked with bung and bead blasted